Lock the welder

Iron Triangle Fender

The fender for my new bike (for the brooklyn invitational, then artistry in iron), has an entirely stainless steel rear fender. Recently I made the wiring conduit that leads the taillight wires from the frame backbone to the taillight location at the rear of the fender. To curve the thin walled tubing, I used a low-tech method that works well for tubing too thin to be formed in my roller- torch bending. Common thought is that using a torch to heat and bend thin tubing would result in the tube collapsing and "pinching", but thats not the case if done right. By heating a large area of the tube to an even cherry red, and applying soft pressure, a perfect curve can be achieved! here she is finished and installed:

fender 1

 

fender 2

 

fender 3